Service
RETRICULATION SYSTEM
|
-----Retriculation system is the most gfficient way to prevent and get rid of under-ground-termites for pre-construction buildings [prior to floor-laying] by injecting Chemical solution into PE pipe |
 |
-----Characteristics of PE pipe -----1. Applicable to general industrial use, for instance food industry. Chemical industry, water supply, agriculture work, golf course, mine, wire and cable duct, natural gas Supplying pipe, sewage, etc. -----2. The weight is lighter than iron pipe approximately 1:5 lt can be bent 20 to 40 times without beinging damaged. -----3. lt tolerates sun light because it has sun proof substance to prevent cracking. PE pipe can also with stand striking force and pressure from burying in the soil. -----4.lt has properties in chemical neutral status so it tolerates acid and alkaline where It can be installed either under the ground or in seawater. There will be no decay or rust. -----5.The surface texture inside the pipe is smooth and shines so there is low friction Where liquid can flow thorung the pipe easily. -----6.The pipe is produced under BS Heavy Standard of Britain so it tolerates to climate change and can be used even in hot or cold climate condition. |
-----Pipe Laying Equipment
-----1. Pipe [or PE pipe] has outside ring diameter 21.4 mm. And 3.3 mm. Thickness.
-----2. Bend joint, internal straight screw joint, internal screw lid, nipple [ external straight screw joint], pipe strapping cam, screw, sprinkler and pulley
-----3. Electric drilling machine for pipe and beam holes piercing.
-----Method for Pipes Lining System Service
-----1.Use an electric drill to make holes and seal a screw tab at every hole of 1 meter apart from each hole. Put a valve for discharge of chemical substance at every hole. turn it tight to prevent the chemical substance valve from coming out.
-----2.Techichians may start his work after construction workers have poured concrete to Soil beams and already have removed wooden forms.
-----3.Technicians will continue too lay pipes as per the plan set out by the company for customer. The pipes must be lined parallel to the soil beam around the building by placing deep from the upper side of the beam 15-30 centimeter. Adjust level of the pipe from internal beam line approximately 45-90 degree From the beam line
-----4.Use pipe strapping cam to strap pipe with beam line of approximately 1-1.5 meter distance from each point.
-----5.Set out a point for installation of chemical sparying head by using length of PE equal to 20 meter per chemical spraying head.
-----6.In installation of chemical sparying head, the must be installed far from external wall of the building of at least 10 centimeters.
-----7.Check completeness of the work and test for efficiency of the pipe linging system before concreting the floor in order to correct any defects [ if any]
-----8.After pipe lining and ffficiency testing the company will inject the chemical.